determined that some Ruger SR9 pistols manufactured between
October 2007 and April 2008 can, under certain conditions,
fire if dropped with their manual safeties in the "off" or
"fire" position. The pistols will not fire if the manual
safety is in the "on" or "safe" position.
We will retrofit all Ruger SR9
pistols starting with serial number prefix “330” (330-xxxxx)
with these new parts at no charge to
In order to ensure correct
fitting, the new parts must be installed at our Ruger factory
in Prescott, Arizona. We will remove the old parts and install
the new trigger group promptly, at no charge, and will return
the pistol to you. The old parts will not be returned.
Step 1 -
Contact us and provide your name, address, telephone number
and SR9 serial number.
information by any of the following:
SR9 Recall On-line Form
SR9 Recall Hotline
(available Monday - Friday, 8:00 a.m. to 8:00 p.m. EDT)
Step 2 - When
we are ready to retrofit your SR9, we will send you a
shipping label and shipping box with instructions so you can
return your pistol to us FREE of charge.
Step 3 - We
will install the new trigger group in your SR9 and return it
to you FREE of charge. When we do, we also
will send you a FREE extra magazine as a "thank you" for your
patience and cooperation. We will make every effort to
return your pistol within one week, so we will not ask you to
send it to us until we are ready to receive it. We expect to
begin sending shipping labels and boxes in late June.
not load or fire your pistol until it has been factory
retrofitted with these new parts! If you must fire your
pistol, be sure to keep the manual safety in the "on" or
"safe" position except when you are actually firing.
Sturm, Ruger & Co., Inc.